Posted by richardinnz on December 22, 2016 at 15:09:59 from (125.238.244.140):
In Reply to: belarus 825 posted by mkoughan on December 22, 2016 at 05:05:39:
The lever beside the seat operates the 3 point in draft or position control, depending on the position of the selector lever thru the hole in the cab floor near the seat on the left side. The right hand lever has a 'neutral' position which can be tricky to find, with nothing on the lift arms, operate one of the remote levers near the windscreen (not the one for the linkage nearest the dashboard) and when the lever beside your seat is in neutral position the 3 point will remain stationary when a remote is operated to cause the release valve to operate, the linkage is prone to siezing, and with the lever etc bolted to the cab, and the valve bolted to the chassis is also prone to coming out of adjustment frequently. IF you can find the neutral position, use the lever at the front, back to raise, forward to lower (power down), farther forward until it locks is float. It sounds as if the right hand lever is way out of adjustment, siezed up, or the selector knob below the floor is not engaged with the external draft or position linkage, you should be able to lift with the right lever also. Adjustment can be obtained by adjusting the length of the operating linkage under the right rear mudguard, removing the seat and the access panel below it fully exposes the linkage and valve for service.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
