Posted by Zachary Hoyt on December 24, 2016 at 12:34:12 from (192.182.200.199):
In Reply to: Recod players???? posted by JD Seller on December 24, 2016 at 11:55:24:
I am only 30 but have a few hundred records I've accumulated over the last 15 years. I've had a few cheap old record players and would replace them when they died. I paid anywhere from $10 to $20 for most of them, as much as $50 or $60 for the last one that I had shipped in. This fall I was needing to replace our old player again, it still ran but would cut in and out, and the arm had some issues with the remains of a changer system. I ended up buying an Audio Technica LP-60 which was about $90 brand new. I plugged it into an old Radio Shack stereo amplifier and it is by far the best sounding and most dependable player I have ever had. I would recommend it very highly. There are "all in one" units with a turntable plus tape, CD and radio but I have not found one with a good reputation online, and the ones I have seen in person at yard sales and such are pretty cheaply made. The LP-60 is also nice because it is automatic, you just put the record on the table and close the lid, then push the start button. My sister could never get the idea of how to set the needle down gently, and she has no trouble with the new machine. I am sure there are nice refurbished older players out there too, but I don't know much about it. Zach
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.