Posted by 2underage on December 26, 2016 at 05:09:00 from (64.19.81.138):
In Reply to: bale spears? posted by mmidlam on December 25, 2016 at 21:18:27:
Not much difference but a few different types. I have sold many that just clamped onto the loader bucket with a chain and turnbuckle and they worked good for those who already had a loader with a bucket. I used one of that type for myself and I like them because it was easy to remove. The other type that I have been selling are the ones that attach like a skid steer bucket. Again, very handy if you have the right loader. Another type is the one that fits your 3 point hitch. They work OK for moving bales but do not work for loading or unloading from wagon or trailer because your lift height is limited. Another type that I have used and sold are the ones that pin onto your loader in place of the bucket. They work good but unhandy to remove when you want to use your loader bucket.
Look for one with a replaceable spear because sooner or later you may bend it. If it is replaceable you can straighten it but you must remove it from the frame first.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.