Posted by RandyB(MI) on December 26, 2016 at 14:06:40 from (75.133.140.129):
In Reply to: Re: Back surgery posted by dhannah on December 26, 2016 at 12:34:56:
I have had the cervicle spine deal , spacers , plate on front , severe spinal stenosis with bone spurs protruding into spinal cord. Yes, little 2-3" slit in side of neck , no muscles disturbed, healed great. SUCCESS ??? depends on ones definition of success I guess. If I hadn't had this done, I would be in a wheel chair forever right now AND with no continence to go with it. Yes we all wait too long.Neurologist took one look at my MRI and called work and told them to send me HOME immediatly and put collar on me and scheduled surgery within one week. That's never done. No you won't get back nerve damage already done. I have some limitations and nerve damage...but NOT from the surgery itself. I don't really care for a wheel chair. I had no choice. What I had, every upright walking human will eventually have. Most don't have it until they are 80 + and everyone just calls it old age. I had it at 62. I thank my Neurologist/Surgeon and am thankful my limitations are as relatively minor as they are. Don't mess around with numbness !!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
