Recently I've noticed a few farmers are bringing in large track-hoes and cleaning out tree rows along the edge of their property after the crops were harvested. I'm guessing the tree rows were once fence rows.
I can see how your tree puller might work on brush and small trees, but the large ones the farmers are removing will require a bigger gun.
The boss wants brush removed from gravel pit so she can plant flowers. The small stuff, Asian honeysuckle, mulberry, other small trees, I can dig out with terramite. The bigger stuff gets cut with chainsaw, stumps remain. Now she wants hillsides cleared. Places that a backhoe can't reach. I use log chains, climb the hill and attach chain as high up as possible on tree. The higher you pull, the more leverage. Tree roots pull out or snap off. One tree had large roots, one side came out the other side I had to remove dirt with water hose and then cut them with chainsaw.
So if you tree puller can't get it done, try using a chain attached as high as you can on tree.
I've been thinking of using straps instead of G70 chains. It's a workout pulling 100 ft of chain up a hillside. Using chains works better if someone is on tractor and the other is climbing the hill.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.