Posted by Janicholson on December 31, 2016 at 20:27:35 from (63.152.229.17):
In Reply to: Re: Plow Question posted by Steve@Advance on December 31, 2016 at 19:32:11:
Assuming you and your SIL do not want to use chemicals to burn down the existing "pasture". I would use a disk to knock down the grass and make it "shorter" to the surface. Then I would mold board plow it. to bury the residual "green Manure" of the pasture. A hobby garden if kept well does not need to be plowed every year, but weed control by hand, or by cultivators on the Massey, is necessary. If less than 2 acres are planned, purchasing a plow might be unnecessary. Having a local farmer plow it that first time might make sense. A tillage disk that can be set to be 4 inches deep would be perfect. Black soil is usually easily returned to usefulness. The black is often organic material, which will loosen and make good garden productivity. The hardness you are experiencing is from compaction for the years it has had animals on it.
Do not try to pull the same plow that an M Farmall would pull with a compact tractor. In that packed soil, I would stay with a 2-12 or 2-14 3 point plow. A pull type plow will be likely worn out or at least need shares and adjustment to make it suck into that ground.
Mixing sand into a small 50'X100' (5000 square feet) plot would take about 10 cubic yards to make a difference that could be measured. 10 cubic yards is 270 cubic feet. That is about 5/8 of an inch of sand per square foot. Spreading it to be uniform is also difficult.
Work up what you have before putting other material in it. The county Extension Agent can help with soil tests and recommendations. Jim
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
