Every once in a while, one needs to upgrade. Back in 83 I had a gas 4010 I'd. Get home from work about 6:00 pm. Want to no-till for a few hrs. Didn't have time for any issues. But seemed tractor didn't know that. Traded it for a new 6060AC Cab and air. Smaller by 25 hp but the cab more than made up for it. Didn't need a 4010 to pull a 6 row planter.or a 10ft. No-till drill. We are not super steep here. But a 60hp tractor is big enough to bale and move 4x5 bales or sq bales. 4 wheel drive is a game changer, going down or up hills or thru wet draws. I am not a fan of 5000 series jd. Check where they are made. Kubotas are better in 50 to 80 hp. Friends tractor 55?? . PTO clutch went out pulling a 10" auger. Dealer said clutches are not warranted. Warned him new clutch would not be any better. Best not run auger with it. Another friends 5??? Jd . Had sand in the housings from the factory. JD finally gave him a $10,000 up grade to a 60?? Plus $10000 of his money to trade. Think it is made in. Germany. 5 years ago my son upgraded the 6060 with a M126 kubota. Nothing lasts forever!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
