Posted by Bill in IL on January 04, 2017 at 10:47:30 from (132.3.49.78):
In Reply to: Binz again.... posted by Dave H (MI) on January 03, 2017 at 17:56:08:
What do you have for an auger to fill these bins with? I would guess a 45 to 50 foot straight transport auger would reach but you had better check you numbers before quoting me. I was thinking if you wanted to transfer grain then place the bins spaced so you could unload directly into the auger and dump into the second bin. Like JD said a swing away makes this easy. Lots of people use 2 augers and a wagon or truck between but when you have the choice it would be best to eliminate that.
As for the semi traffic I would leave at least a 75 foot minimum circle for a semi to pull in and swing around. They will want an easy hopefully somewhat straight run get back on the road when loaded.
The idea of putting the bins footing up a foot or so for the unloading auger is good advice too. I have one bin with low clearance and its a pain when its sump underneath is filled with water or worse ice. Adding and upswing unload auger can make up for low clearance but that adds expense and power requirements from the unloader motor.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.