Posted by jimg.allentown on January 07, 2017 at 06:23:50 from (108.36.80.118):
In Reply to: Way OT - printer! posted by Hank ABAB on January 06, 2017 at 12:50:17:
One thing that I do not see anybody telling you is the cost per page. Laser versus inkjet, you can print much more economically on the laser. The big bite is when you do have to replace the toner or drum. BUT, when you account for how many pages you print with each one, the cost per page goes way down. Most inkjet replacement cartridges (when I used inkjet) cost me around $30 or so for each one. They would print a few hundred pages. A laser toner will generally print from 5,000 to 10,000 pages before you need to replace it. And, a replacement will cost around $80 to $100. So, while nobody likes to have to shell out the big bucks at replacement time, it still turns out to be less costly in the long run. There are a few other advantages to the laser. You never have to replace a cartridge or print head because the ink dried out. The printed page comes out of the printer dry, and does not smear. If you get a laser printed page wet, the ink will not run or smear. Ink jets only have the advantage for printing high resolution graphics like photographs. For that, it is cheaper to take your memory card to the local drug store and get better prints for less than you can do them at home.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
