You have to see how the hitch works out with drawn equipment. The rear tire can hit the hitch if you turn too sharp. Be careful of this.
It can be hard on the inner openers if you turn real sharp with a drill down in the ground. A nice gentle turn is likely fine, but real sharp, brake locked on the tractor, isn't so good. You are forcing that opener to pivot in the ground, rather than cut through the ground while moving forward.
A disk without wheels is generally designed to flex when you turn and won't hurt it, but you just can't turn real sharp anyhow. If the disk has a lift cylinder and wheels those generally it is very hard on them to leave in the ground and turn sharp, lift them at each end for turning around.
You will learn to make 3-4 passes around the field with either the disk or the drill, and then travel back and forth using the ends to turn around on.
It can be difficult in tiny patches of fields, but that is how it is, one works out a system pretty quick.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.