Posted by LA in WI on January 25, 2017 at 13:26:03 from (162.245.179.116):
In Reply to: 2 bottom plow posted by Thageneral81 on January 25, 2017 at 07:51:43:
Another thought for you: 1. Don't alter your MH30, you have a good old tractor that is not real common (but not rare) and it was built in the trailer plow era. You might end up some day regretting what you did to that tractor. 2. Find a good 1 bottom 14" or 16" trailer plow, or a good 2 bottom 14" trailer plow. The "30" is rated at 21 drawbar HP so you want to make sure you stay small enough to plow without making the tractor work too hard.
In Wisconsin we rarely see a MH trailer plow at auctions (they are more common in the East) but an IH #8 Little Genius or #44 JD plows are very common and will work behind any old tractor.
I would look for a 1 bottom 14" or 16", an excellent choice would be a 2 bottom 12" trailer plow but those are very hard to find. Depending on where you live, I might be able to find you something. I'm retired, and can't resist farm auctions with old machinery. LA in WI
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
