Posted by Steve@Advance on January 31, 2017 at 05:04:57 from (24.182.105.179):
In Reply to: Cautionary tale posted by Harold Melius on January 30, 2017 at 21:59:29:
The chlorinated cleaners are the ones that make phosgene gas. The cleaner itself is not flamable, but the propellant in the can, usually propane, is flammable. That can be very misleading when using it around an ignition source, as in cleaning an electric motor.
The phosgene gas is created when the solvent is exposed to high temperatures or fire. The single poof of fire you experienced wasn't likely enough to cause harm from the gas, but could have started a larger fire, or as happened, some singed eyebrows. What was actually burning (if it was chlorinated cleaner) was the propellant.
What can cause poisoning though is using brake cleaner for locating vacuum leaks, or spraying into a running engine. The exhaust then becomes the source of the phosgene gas. So can using chlorinated solvent in a room with a heater, get the solvent hot enough or exposed to flame and the gas forms. You will know it when it happens! Takes your breath away, you need to breathe but your body says "no you ain't"!
As for the flammable cleaners, like carb cleaner, they don't make any toxic gasses, nothing more hazardous than carbon monoxide similar to burning gas or diesel. The danger is the flammability, similar to gasoline.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
