Posted by tomstractorsandtoys on February 01, 2017 at 19:54:58 from (50.105.219.70):
In Reply to: Selling point? posted by marcusoverholtzer on February 01, 2017 at 16:28:29:
I would only convert it if you can do the wiring yourself. I make my own harness so the only big cost is the starter and a Delco Alt. and new cables. It is a very time consuming job running each wire then crimping ends and shrink wraping them. I them put the finished harness in black loom.You could make your existing harness look much better by repairing the worst wires and the adding the plastic loom to the entire harness. It will look much better and be safer as well. Getting money out of repair jobs is getting harder. I have a 4020 that we bought with water in the oil that owner said had been setting awhile. He lied as when tore down six of the main bearings are spun and the crank is junk. We put a gas motor we had out of a combine in it and are hoping to break even on what we have in it. Overhauling the engine correctly would make the tractor way overpriced, so rather than spend all the hours of time and get nothing we are selling it as a gas. Tom
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
