Posted by WellWorn on February 03, 2017 at 09:11:50 from (64.66.127.214):
In Reply to: ot again posted by 55 50 Ron on February 03, 2017 at 08:25:25:
Ron, your Fluke meter should have a "diode" test setting. It should show somewhere around .500 to .750 (voltage drop) in the forward direction, and "inf" in the reverse direction. A standard ohms check won't tell you anything except if a diode is shorted.
The number of diodes has less to do with the capacity of the charger than the ratings of and cost of each diode. When they first made it, it was cheaper to use 6. Now it's cheaper to use 4 of a 50% higher amp rating. You can replace all the diodes on that plate with a couple stud mounted rectifiers like this that would never blow out: http://www.digikey.com/product-detail/en/vishay-semiconductor-diodes-division/VS-300U30A/VS-300U30AGI-ND/352844 but the cost is probably prohibitive.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
