Posted by Angle Iron on February 04, 2017 at 06:41:28 from (73.131.52.171):
In Reply to: Filling the radiator posted by jasonteem on January 30, 2017 at 14:43:39:
Quoting Removed, click Modern View to seeI had an early fifty's international truck with a mounted corn sheller. Big sleeveless six, 304-308 in line I really do not remember the actual size. I had it bored 60 over to clean up the bore from being rust stuck. I thought that had something to do with the fact that it always ran on the warm side load or no load. Had to be real carful when working it. Had the radiator redone, no help, modified and mounted the blades from a gm clutch fan without the clutch. Sounded like a jet engine at operating RPM's. Still ran warm to hot. Was talking about it with the guy I bought it from one day and he asked if I had a thermostat in it and I said no. He said that engine would always run hot without a thermostat as the water didn't stay in the radiator long enough to transfer the heat. Put one in it and ended the problem. I could work it as hard as I wanted on a 100 degree day and it cooled just fine. I really didn't think it would work but had tried everything else so thought why not. Put a thermostat in it and try it, your not out much and it needs one anyway.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
