Posted by steve terplak on February 04, 2017 at 11:57:21 from (162.72.14.70):
Hey all, ACG's post about skidding logs got me thinking...
I have tried a few different methods of sharpening my saws over the years... Hand file - I struggled to get it real sharp...never quite got the technique right. Dremel - lacked consistency tooth to tooth. Cheap electric - got it nice and sharp but angles were never super accurate and I burned through chain faster than I should have...
Wife got me the Timberline sharpener for my birthday two years ago. I love it.
It is a hand powered, bar mount rotational file...easy to use...can do a chain in 15 minutes...does an excellent job of keeping the angle and profile of the tooth....gets them razor sharp and no chain removal...
During wood season, I keep two chains sharp for each saw, and that can get me through 3-4 half days of work.
I burn 15ish cord and think this sharpening system has been worth the price for me.
Didn't know if anyone else had seen it or used it?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.