Is you machine a Clipper? I haven't heard of a 32. If it is a clipper, you can buy them direct from Clipper. for a 7 series machine, they are $30 each. I ended up buying ball trays and removing the brushes. They're basically boxes with screen bottoms that hold little rubber balls. The balls bounce just enough to knock the junk out of the screen holes. They're about $250 per screen & another $30 for the balls. The guy also sells a hardware kit to make them removable for $125, but I didn't buy them. I'll just screw them directly into the machine. Here's a link to the maker, Chalk Farm in Portland OR - http://www.chalkfarmballtrays.com/ordering
To unload it, I am going to install a cross auger under the machine. The cross auger will dump into a lift auger that will drop into a gravity box, or into a drop to fill bags. I bought the poly cup auger from May Wes. The 5" costs $23 per foot. Here's a link -
As far as you machine shaking, you might have something wrong. On a Clipper, you should be able to set a quarter on the frame, and it should stay put. You might not have you machine secured well enough, or you might be running it too fast. The shaker shaft should run at 400 or 410 RPM. Running it faster really won't give you more capacity, and it will shake itself apart.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.