Posted by oldtanker on February 17, 2017 at 06:46:09 from (66.228.255.59):
In Reply to: Weapon for Equipment posted by JimS on February 15, 2017 at 09:38:38:
Quoting Removed, click Modern View to see
The Remington .233 (AKA 5.56) started life because of what the US military wanted. And correct, a dead soldier if need be can be left where they fell. Wounded man requires a medic, litter bearers and such. They figured back then it took 6 men to transport wounded soldier to an aid station. Plus the assets treat/transport the soldier after they reached the aid station. Against an enemy who is concerned about taking care of their men it works. Against others, not so much.
Another factor involved with this is studies conducted both after WWII and Korea. The average infantry soldier was reluctant to take a shot further than a couple hundred meters. So why issue a rifle and ammo capable of 800 to 1000 yards? Soldier could carry much more ammo too. The basic load in 1776 was 40 rounds. WWII 80. With the Load Bearing Equipment (LBE) issued after the M16 was adopted the Mag pouches carried 4 mags each and 2 pouches were issued. Plus more ammo could be carried in fanny packs and ruck sacks (back packs). Mission dictates load out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
