Posted by Leroy on February 17, 2017 at 07:21:51 from (69.88.202.2):
In Reply to: Cyclone Seeder posted by rwalton1961 on February 16, 2017 at 16:14:27:
Dad had and I still have a seeder of that style and I don't think it ever came from factory with a chart. And mine is electric motor powered,just a heater motor. Dad would not have a PTO powered unit as if you would slow down to cross a rough spot the width of the spread would drop off to nothing and as soon as you speeded back up again it would do the spreading. When you had to slow for that spot it still ran out the seed at the same rate but did not put it out to where it was supposed to be. Ever watch a salt spreader on a snow plow truck? when out on straight road spread wide when slow down for the stop sign the fan slows and does not spread the salt and when the truck fully stops the fan stops completely and the salt keeps dribbling out and that is why you see big piles of salt anyplace the plow truck stops. Andthose seeders do the same thing with the seed.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
