Posted by Leroy on February 18, 2017 at 06:44:20 from (69.88.202.2):
In Reply to: Subsoiler Question posted by John B. on February 17, 2017 at 15:14:05:
The subsoiler like he is asking about will generaly cut omly 10-12" deep, not the 2' like what you guys are talking about andthose around are refered to as deep eippers, Have never heard of a subsoiler with more than one shank. Several years ago a friend ran his 1 shank over my field and it seemed to do quite a bit of good. And his was a bigger tractor than most of thase single shank subsoilers were made for, it was an Allis WD. And never heard of one having a coulter but under trash it would be a good idea. And as for leaving the ground smoother the more it is piled up beside the cut means the better it has cracked up the hardpan as loose dirt will always take up more space than hardpacked dirt will. You always use a subsoiler in later driest part of summer, never when ground is damp let alone wet. The mole that takes more power to pull than the average tractor that would be pulling it has will crack up the ground more than a shank without it. Unless you have a heavy duty pull type, no 3 point hitch and made for the mole the unit would not be strong enough to add one. And chaces are it in just a short will would be no ware to be found being burried underground someplace. Your disk chisels are designed to work deeper than yjose single shank subsoilers were designed to go as they were designed to break up the plow hardpan that was 6-8" down.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.