Posted by kcm.MN on February 20, 2017 at 09:04:21 from (174.219.9.236):
In Reply to: Buying a house AS-IS posted by Brent Zappe on February 18, 2017 at 07:24:30:
Quoting Removed, click Modern View to see
Wow! I didn't think "anyone" had less than our 2 GPM. In extreme NW Minnesota here, so have more water than we know what to do with (high water table). Back to your 1 GPM, have you considered getting a 500 or 1,000 gal. storage tank with its own pump? You could then have a real shower. *lol*
Nice house (in the OP), but I gotta have trees! Planning on building a (roughly) 40' x 60' shop this year, but not going "normal" construction. Going to build with straw bales instead. And using packed soil floor rather than concrete - at least that's the plan for now. Can always add concrete on top at a later time.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
