Posted by kcm.MN on February 24, 2017 at 07:34:28 from (174.219.13.18):
In Reply to: Another tractor tiedown ? posted by Dave Sherburne, NY on February 23, 2017 at 17:06:26:
I, too, do not understand about load binders putting you over width. When using stake pockets, I've always dropped a chain end down the pocket and hooked upward, then put the load binder inline.
Also, I have NEVER(!!) had a load binder come loose on me, and for one very simple reason - because I was taught from an early age about always wrapping excess chain around the handle. If I don't have enough excess chain, then use rope, baling twine or even several wraps of duct tape.
I had a load "settle" on me one time. Chains slackened, but kept an eye on the load as I was expecting as much. The load binders were still just as perfectly locked as when I left, as it was physically impossible for the handle to pop open. And yes, I always use an extension bar - what I grew up learning as a cheater bar - also good for breaking rusted-on bolts free. ...Have broken a few sockets and ratchets in my time though! :lol:
Honestly, I cannot understand why normal load binders would be outlawed in any state. It all boils down to doing things the right way and not being careless. I don't even own a ratcheting binder and probably never will as I've got 20 miles of gravel road and very long winters - both of which can gum up a ratcheting binder. Sand and rocks are hard on the gearing!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.