He is wasting his time. First thing to prove is why he got the wrong fluid. Did the customer do his own homework? He should have an owner's manual to tell him what fluid to use. Fluid requirement should also be stamped into the dipstick. I know that it is on Ford products. Second, he would need to PROVE that the fluid he used actually CAUSED the damage. Not an easy thing to prove.
While the wrong fluid can shorten the life of a transmission, the effects of using the wrong fluid will take some time to manifest themselves.
As to engine "issues," in my mind, there are only four basic "issues" that I can figure: 1) noises/knocking 2) oil consumption or smoking 3) Leaking 4) compression or drivability issues.
Engine noises are generally internal, and should be covered under a warranty. Oil consumption is a definite cause for concern. An engine sold as being rebuilt should not use oil. Most leakage comes from assembly/installation problems. If you buy a short block, do not expect a warranty on the head gaskets! If you buy a long block, there can still be issues with the installation of the parts from the old engine - like manifolds, oil pan, and valve covers. Unless a person buys a COMPLETE engine, there will be more issues with installation that with the engine itself. Again, not easy to prove who is at fault.
My advice is to tell the guy to put on his big boy underpants, take the blame for his own shortcomings, and leave the lawyers and government out of it.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.