Colin, If the planter is in good shape and free of rust, then it should serve you well for a few years. When you buy your seed corn have the seed dealer help you with the plates to be needed. If he knows nothing about plates maybe consider a more knowledgeable dealer. You will need "sized seed", meaning you should not plant seed for plateless planters as those hybrids are a mix of whatever seed sizes the seed company needs to put together for any given year. DO NOT let seed size influence
you in any way regarding yield....all seed from a given hybrid are the same for vigor, standability, yield, etc. There is no validity to the notion that sized seed yields less than plateless seed or vice versa.
Please get an Operator's Manual if you do not have one. The manual will show you which "driver sprocket" needs to be aligned with a certain "driven sprocket" to attain the plant population you want. Without that knowledge, you are "flying blind". A poorly planted field will haunt you all season.
When first starting to plant, drive a short distance, get off the tractor, grab a knife or trowel and dig for the seeds you just planted to see what depth and how close together the seeds are. This little exercise can be very valuable and might stop you from making an expensive mistake on all of your acres. Your seed should be about 2-2 1/2 inches deep....if very dry then see if you can get the seed a little deeper to get to moisture. I suggest you not plant deeper than 3 inches.
Any other questions you might have we can help you. There is also a lot of poor advice available so you need to sort that all out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
