Posted by JohnDeereJimOhio on April 04, 2017 at 09:29:55 from (172.77.148.135):
I just scheduled to have a 40x60x14 pole barn built, it will have two full lean too's 12 foot wide... main roof pitch is 4/12 lean toos will be 3/12 contractor said at lowest side of lean too I will be at 10 foot tall.. contractor is usuing all metal, wrapping whole building in bubble wrap or drip wrap. 6x6 post in main building and 4x6 on lean toos. Main front door will be 16w by 12h with electric opener. Building will also have a man door front and rear. It was priced with 4-1/2 in concrete in main shop for just under $40,000 dollars.. I will be installing water electric and pex piping pre cement for in floor heat. This shop will be used to house tractors and vehicles as well as work on them and do some fabricating work. Lean too's will be used to store equipment trailer and horse trailer. As well as hay and other equipment.
So my main question is before they show up to build this in May is there anything I should change or anything else I should do based on your guys experiences with buildings you have built.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
