Posted by Andy Martin on April 18, 2017 at 21:36:21 from (209.213.149.120):
In Reply to: Drawbars posted by Eldon (WA) on April 18, 2017 at 19:03:28:
Nothing will break if you put over 552# on the drawbar. Like the manual said, speed and rough ground greatly increase the loads on the drawbar. They designed the drawbar to survive bouncing over rough ground with 552# on it, and in addition will have a safety margin designed in. Think 1/2 ton truck. And tires, you can greatly overload tires if you are going slow over smooth ground. At some point over design load something will break, but it is likely closer to double the design load (or triple) because impact multiplies loads tremendously.
552# and 556kg look suspiciously similar. I'd guess some young engineer screwed up one of the manuals. Now, which one is wrong??
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.