Posted by dhermesc on April 25, 2017 at 07:59:33 from (24.248.193.103):
In Reply to: Re: f 600 ford posted by Shaun Wallace on April 24, 2017 at 20:17:22:
The blocks are the same with one small variation; the hole in the block where the distributor shaft goes is of a different inside diameter, with the light duty and passenger cars being smaller, So, the truck distributor will not fit into the FE block. The light duty distrbutors will fit into the FT blocks but not have the side support needed and will cause the distributor gear to wear rapidly. Also, the oil pump key/driveshaft is a larger hex on the FTs and require the larger FT oil pump.
The crankshafts, both iron and steel, are the same with the exception of the snout being of a larger diameter on the FT and if the crank is to be used in an FE the snout diameter must be reduced to the same dismeter as the FE's and a new keyway cut. The FTs are internally balanced to a lower rpm and must be rebalanced for higher rpm usage. My understanding is all FT engines have steel cranks, SOME of the FE engines have steel cranks.
The rest is nearly all interchangable. The heads of most FTs and industrial engines have a dual manifold heat passage, small intake ports and valve rotators on the smallish valves. The pistons will usually have a dish or reduced piston pin to piston crown measurement to reduce compression.
The 330MD (medium duty) is very rare and probably not found in a F600 - especially stock.
The 330HD (heavy duty) is fairly common and I've seen it in several F600s - I believe it was the "base" v8 engine and the 361 was optional. A lot of state trucks had the 330 engine if they didn't have the old 300 I6 installed.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather’s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
