Posted by JDEM on April 26, 2017 at 06:56:25 from (70.194.21.186):
I am at near the "end of my rope" with the trans in my truck. My main question is this. Truck is a 1994 4WD F250 turbo-diesel 7.3 IDI with an E40D trans. It there a way to unhook the lock-up torque-converter when cold? Note I already tried the most obvious approach with a simple on-off switch and no good. It winds up putting the trans into "default mode" and then have to get out my scanner and clear the codes before the trans will work right again.
I have had many issues with the trans over the years. I finally bought a remanufactured complete trans and installed it last year. I gave up on the old one. With the old trans - after a rebuild - I stopped at a red light. Then tried to go and nothing. Just a little clunk and then no-go. Ended up a solid steel shaft had snapped right in two. After that - I was leery of metal fatigue with the old trans and bought a complete replacement.
The problem with the new trans is the converter. When temps are lower then 60 F and at first cold start - the first time the converter locks - it stays locked. It nearly pushed me through a red-light the first time it happened. Once it warms up it is fine and I can drive it all day with no issues. Next morning if it is cool out - it happens all over again. Trans is still under warranty but that only covers parts, not labor. I assume this has a defective converter and the right fix is to tear it all apart and change it. I just don't want to. If I could just find a way to turn the converter "off" until warm - it would be fine.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
