Posted by kcm.MN on May 03, 2017 at 19:00:36 from (174.219.4.14):
In Reply to: Carport again posted by super99 on May 03, 2017 at 17:48:33:
Several thoughts here:
1) First of all, those don't look like they would provide adequate structural rigidity even if they were steel. You could replace them with some steel channel of the same dimension, but I would put thru-bolts with lock nuts.
2) I would also make replacement braces a bit longer than original - like maybe 6" to 10" longer in each direction - 12" to 20" overall longer braces.
3) you could take some rebar or other cheap steel and weld up a super stiff brace for each end that would follow the contour of the building. Could make the web about 6". When done, just bolt the bracing trusses to the inside of each end using adequate bolts/nuts, so as to still be able to disassemble if ever needed. This would narrow your opening height by about 4" and the width by about 8", but looks like there's still ample room to get in and out.
I don't know about there, but if we had one of those here, it'd better be anchored securely to the ground, otherwise it'll probably end up in the next county....or Canada!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
