Don't care for that method and would never recommend it to anyone. Yes, I have tried it without success, snapping an 8" diameter hardwood log, cinching the tire so tight it should have popped off the rim or damaged the tire and tube. Both happened quickly and without warning. Had there not been a loader on this one,using forward gear could have flipped it over, which to me is like a human snap type mouse trap. Using the loader to push it out did not work this time, but I had done it once in about the same place 10 years before. This tractor was bottomed out front and back and at that point the method of chaining a log to the rear wheel was a bad decision that could cause serious injury or death. It's evident that under more ideal conditions, that it can be successful, but not every tractor operator is going to know the difference. The method has definitive limitations, which when exceeded, can and will have consequences. If the operator does not consider the reactions that can happen, its a bad decision to make.
What worked FAR better was a chain hoist connected to the very base of what was a 4" young black cherry tree. It also helped that dry weather improved the ground conditions. If it happened again and there was no tree to rig to, I'd set multiple deadmen at an opposing angle and rig off the base of them with a chain hoist. No matter what, there is going to be hand digging, might as well make it count.
All I needed was that small tree, never thought it strong enough until I tried. It never budged.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.