Posted by Geo-TH,In on May 10, 2017 at 04:26:00 from (172.78.82.129):
In Reply to: red barn paint posted by Mi-Bill on May 09, 2017 at 09:12:50:
Bill, I'm no paint expert, but I do observe paint failures on many metal buildings in the country. I would be going to a paint store and getting their advice. We used to have a sherwin williams store in town. I went there to buy paint for galvanized metal. They sold me a good primer and paint and it worked well.
My biggest concern is mold. I've noticed mold growing on metal buildings that have been re painted. So I would seek professional help and find out if there is something to put in the paint to stop mold.
I have to power wash vinyl siding annually and it's a Big pain in the ankle. BPIA.
I own homes with aluminum siding and haven't had to do anything to siding in 40 years.
I've noticed the new barn siding is very shinny and no mold. Get ahead of any potential mold issues. Seek professional help. geo
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
