Posted by Ultradog MN on May 12, 2017 at 16:45:23 from (172.58.83.112):
Back in the 80s I was a pretty fair welder. Mostly was a stick man. Probably burned a ton or two of 7018. I remember thinking then how welding was a lot like a long, drawn out isometric exercise. You brace yourself as best you can and once you strike that arc you hold it just so... till the rod is burned away. No matter what happens in that minute or two while its burning, an itch, a cramp, a hot spark down your glove, your focus is on that arc and you hold it just so in an isometric exercise. Kinda like Tai Chi in a way. So right now I'm finally putting some paint in our new bedroom. Up on a scaffold with a sash brush, cutting in where the walls meet the ceiling. And it's like an isometric exercise in that you hold that line whether you get an itch or a cramp or a fly lands on your ear like just happened. I think you gotta like to weld, or paint, to do it well. To hold your arms just so and control your breathing and forget the itches and the sparks and flies. And focus your entire self on that bead or paint line that you're cutting. Make it as perfect as you possibly can. Plus some. You cannot paint a line into a corner with masking tape or an edging tool and have it turn out nice. You gotta do it like it means a lot to you. And the only way is free hand. Just like laying in a nice bead of weld. There's no tool or gimmick that will do as well as your own free hand and liking it and understanding it's an isometric exercise.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
