Posted by flying belgian on May 15, 2017 at 21:13:50 from (216.114.233.126):
In Reply to: IH plows posted by Tony730 on May 15, 2017 at 18:40:23:
I can't speak to the Case vari-width but I have a 4 bottom JD vari-width. Goes from 12 to 24". Set at 16" it will pull much harder then a fixed 16" because at least JD. uses a 20" mold board. So you have much more friction and are lifting the dirt higher. I pulled mine with a 120 hp. fwa. McCormick and could only pull it set at 16". That plow pulls Hard, hard. I now have a 210 hp. Cat trac tractor and set it at 24". Gives that Cat quite a work out. I am not breaking any speed records and you would think that Cat could just play with 4 bottoms. I know you're 4020 would not have a prayer with my JD. 4 bottom. At least not in my S. central Mn. black gumbo soil.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
