Posted by Norm Wampler on May 18, 2017 at 16:53:10 from (199.68.115.251):
Don't laugh, I couldn't do this again if I tried.My 135 Massey Ferguson was stuck in gear and I had the fill cap off and was moving the gear to free it with my mini-mag flashlight in my mouth.I dropped it, it bounced, and went right down in the hole and to the bottom. Any ideas on how to get it out???? My only one so far is to get a good extension magnet and try to find it. Ant suggestions will be greatly appreciated. Thanks, Norm
To all! Thanks for all the suggestions. I have been trying to get it for several days now. So far, no luck. I drained it and borrowed a good Rigid brand camera and actually located it, but it is all the way down by the drain hole. I have tried magnets, grabbers, wire, and still cant get it. 44 Massey, how in the world did you get a hold of it and get it out past all the gears???? Anymore help would be great. I am about worn out with it. Thanks, Norm
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
