The Dawn finger closing wheels work well. DO NOT use the double wheel setup in pure no-till!!! They will dig a trench in some soils. I have had better results just using Dawn finger closing wheels on one side and the factory wheel on the other. The factory wheel acts more as a depth gauge wheel than a closing wheel. You run much lower closing wheel spring tension too. I would also recommend the Dawn drag chains too. They will smooth the closed seed trench out and it will not wash as bad when your planting on steeper ground. The best chains are square type of links that have a twist in each link. These stay on the ground and drag evenly. The cheaper chains will drag and dump. So you end up with mounds and divots rather than a smooth seed trench cover.
The curved tine closing wheels will have issues in your clay soils IF the ground is damp. The tine wheels will snow ball in the wet clay ground.
Another thing that may help you is using CIH depth wheels on your JD/Kinze planting units. They have a smaller diameter right against the opener disk. This tends to leave the ground right at the seed trench "V" looser. This makes the closing system have less compacted side walls to close. In no-till this helps in worked ground it can cause issues. More loose ground than you need at the seed trench.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.