Jim, times have changed, around here anyway. The www says County Line but when you go to the store it's something with no name on it and it has a Behlen Co. instruction manual in the little black tube attached to the unit so I assume Behlen makes them.
I bought a 6' this spring, 54 tines, seemed to be heavy duty enough, and did a lot of www shopping first. Went to TSC as they were local and had 2 of the above in stock, $2k. Bought it, brought it home and put it to work.
I found that there are apparently several manufacturers that have a different way of supporting the structures but get it done anyway. All seem to have the same imported gear boxes which seem to serve the purpose. Prices are similar that I saw. I did see a Red King Cutter at another dealer later (didn't know KK painted some of their implements red) and it seemed to be a heavier duty with mounts for a 3pt quick connect system like JD offers...neighbor has one on his new 4052. Didn't see nor check the price as I already had one.
I got mine home and put about 10 acres of Austrian Winter Peas into the soil....soil if you want to call it that; hard Houston Black Clay. Never missed a beat. I did have to wear ear muffs the whole time.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
