Posted by RandyB(MI) on June 12, 2017 at 18:22:48 from (75.133.135.198):
In Reply to: Recurve Bow info posted by Heyseed on June 12, 2017 at 06:44:24:
I'm pretty sure that's a "Bear" bow by the looks of the little inset and model# starting with "B" . They make a little "bow stringer" which consists of nothing more than a bow string with leather cups on the ends that attach to each end and you put your foot in center and just pull straight up on bow with hand grip and slide the loose end of string out until it slips in it's groove on end and then let back down on bow. Nothing to it and no chance of twisting and breaking laminate. I , too, grew up on "Bear " recurve bows from Chippewa Archery in Mt. Pleasant , MI...south of Grayling where they were made. I have been told , take it for what it's worth, as old as these bows are, it's not a good idea to string one up and actually use it as the laminate could , and has, let go just from age. Could get ugly. I have two nice ones also , one was my first bow when I started hunting back in 1966. I would love to string them up and shoot but I won't chance it. Check with a reputable sport shop for length of string. String technology could have changed since they were built.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
