i understand the respect part. could go on for a while about that topic lack there of in today's society.. but for funeral processions, the living that are driving near and around deserve more respect for their safety than respecting the dead. not meaning to sound crude but that's the reality.
in Indiana you cannot simply stop in the road and block traffic unless its an emergency vehicle. in fact if you are driving too slow and impede 3 or more vehicles behind you from driving a safe speed you must pull over. its actually a pretty good fine. i've never heard of it being enforced though.
if you read the link. all the states state the procession must exercise "due caution".. that would also applies to everyone else.. so "due caution" would mean you don't stop on a freeway.
reading the Indiana code i see it says the lead car must have blue and red flashing lights. i've never seen a procession around here with blue and red lights. The law does not say you have to stop. only yield right of way at intersections. I would think the laws (some do) should state the lead vehicle must follow all traffic laws and THEN proceed and the procession can have right of way at intersections.
this is also confusing if you're in a procession. i've stopped at stop signs when driving in a procession. not worth the ticket or the hassle trying to get out of one. code states: "Before assuming the right-of-way, a person who drives a vehicle in the funeral procession must exercise due caution with regard to crossing traffic".
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
