Posted by Ultradog MN on June 27, 2017 at 03:57:33 from (172.58.86.169):
In Reply to: ford 600 PTO posted by bbailey on June 26, 2017 at 19:42:30:
As suggested below, grab ahold of your pto shaft and see how much in/out movement there is. More than about 1/32" and the snap ring inside has been popped out of place which causes the pto to disengage. Very common problem on those Fords. The usual cause is from a drive line on your mower being too long and when you raise the lift the geometry causes the driveline to push that snap ring out of place. So check your drive line length to keep it from reoccurring. Repair the snap ring by draining your rear end oil, remove the 4 bolts that hold the pto shaft in then grab the shaft and pull it out of the tractor. On a difficulty scale of 1 to 10 with 1 being adding air to your tires and 10 being overhauling an injector pump your project is about a 1.5 Good luck and welcome to Yesterdays Tractors.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.