Well your not alone , My buddy calls me Sunday evening and say he has hyd. oil running out from under the seat on his 1066 when he uses the remotes . OK so you have Hyd oil running out from under the seat so now tell me the WHOLE story . And i get WELLLLLLllll ya see i was rushing to try and beat the rain and get that field done in beans and i am not use to this County drill with the dolly wheel and well i caught the hyd hoses while i was turning and ripped them apart and now i have oil running everywhere . SOOOOOOOooooo Monday i go take a look and lets just say it is NOT a simple fix . He about ripped the right hand side seat support with all the Hyd valves and remote valves along with the seat off the tractor , them were some tough hoses . NOW the fun part is trying to find 1 1/4 x 3/8ths bolts We got 1 inchers on hand we have 1 1/2 on hand NO 1 1/4 x3/8ths anywhere in a half days driving distance . No room to drill deeper and use longer and one inch is not enough . So endth day three and the 1066 is still down. Guess i will have to make two bolts up .
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
