Posted by Case Nutty 1660 on July 15, 2017 at 06:31:36 from (75.127.24.87):
In Reply to: Re: Chinese ATV posted by JDEM on July 15, 2017 at 06:11:53:
I have both atv )four wheelers) and last fall I bought a new Polaris Ranger 900 XP,, both have their uses for sure you should be able to get by for years with a 4 wheeler well from the sounds of it,, I bought my first one new in 1992 and have not been without one since,my Ranger is my third hand and I will never be without one again, I use it to run to town and do everything my pickup used to do on the farm only it is ten tines nicer to use, as for the one in the pic,, for that money if it runs you a year or two I would think you would get your money back out, of, my cousin bough a side by side made there,, it works fine for him so far with no issues, he gave just over 9 grand for it with a plow and folding windshield, you are right on the price as my Ranger was right at 20,000 the way I have it equipped, cab enclosed heater windshield wiper dome light,, seems high but it was new and I know the history as I was not giving 12-15 grand for one with 3000-10,000 miles on one, in my pic you can see how mine is setup and one of my 4-wheelers with atow bar for moving equipment by myself,, cnt
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.