Posted by 21hunter on July 23, 2017 at 11:27:30 from (72.11.21.99):
I have a Massey Ferguson 175 tractor that I'm replacing the fuel filters (Part #1851 890 M1) on. The filters are the CAV 296 type used on many tractors. Attached is a picture of the filters. The original filters are on the bottom and the aftermarket replacements on the top. The inlet side of the filters is on the left? and the outlet on the right? of the picture. The original filters have a solid plate to cap the end thus the fuel is forced to flow from the outside in or inside out depending on how the housing is plumbed. The replacements do not have the plate and it appears that fuel could flow axially through the pleats from one end to the other. Shining a flashlight through the slots on the one end of the filter reveals large gaps in the pleats and appears as if the fuel would not be filtered at all. My question is; are these the wrong filters for this housing? Am I overlooking something? Thanks
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
