Posted by 55 50 Ron on July 29, 2017 at 20:34:44 from (69.24.189.1):
I suspect some of you have used a 12 v gen in a 6 v system and had it work successfully. I'm working on a 6 v pos ground system that was reported not charging. I found the gen to be labeled as a 12 volt unit. It has a "new" 6 v pos gnd voltage regulater. Ammeter shows small charging, but I measure only 6.5 volts at the battery posts which is too small to really charge so the ammeter showing charge puzzles me. Battery is a new Delco and my next thought is to charge the battery for awhile from an external charger. Yes I did polarize - I know about that. Have also cleaned rust and paint from various places so the VR and gen have good chassis connection. I'm a "sparky" but feel like this system is outsmarting me! Oh yah, the question will probably come out "Do I know for sure that the gen is good"? No I don't and that will be another avenue of "research".
As you can probably tell, I'd rather write about it instead of work on it, LOL.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
