Posted by coshoo on August 02, 2017 at 12:03:58 from (65.101.149.33):
In Reply to: nitemare of quitting posted by olgentdc on August 02, 2017 at 05:49:25:
You have it easier than most, in that you have options. Not more pleasant, but easier.
About the only reason to keep a "legacy" together is if the next generation wants it. Yours clearly doesn't, so if I were you, I'd cash rent the farms out, maybe keep 10 or 20 acres near the farmstead to play with hay and your equipment. But it sounds like "the thrill is gone", so you might just want to get out of farming completely.
I quit hay when I was in my late 50's, and realized that haying while holding down a full time job was kind of like banging your head against a wall- it feels so good when you stop! Oh, I liked the cutting, raking and baling, but with old equipment it seemed like something was always breaking at just the wrong time, and you're out there in 95� heat rolling around in the dirt trying to get it fixed. Remember to put your tools in the shade, or you'll burn your hand the next time you pick it up. Grrrr. . .
You have the luxury of taking some time this winter to think about what you'd like to be doing in your life, and then proceed accordingly.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
