Posted by LOU from Wi on August 08, 2017 at 13:26:34 from (98.125.153.14):
We've have one more thing to do. Need metal bestos 5 ft and a rain cap for the outdoor furnace and then we're set to go.When we turned the circulator pumps on,( the boiler tank holds 400 gallon of water, which means that the water temp 0f 170 deg plus) will heat the house and garage a comfortable 74 degrees or better, but we found 3 leaks at the heavy bronze fittings, had to shut off the hot and return side at the circulator so we could drain the water out and re-solder them. Now that those are fixed, we have to re-wrap the insulation for the pex pipe and add the rust inhibitor, which will be done today.The outdoor wood furnace will be a saving grace in more ways than one.#1 no more smoke and dust in the house, and above all, it does away with the fire hazard. My son has to do the same operation as we have, will haul the concrete rerod and mixer over to her house using the 706 tractor for hauling and lifting. I just thought you might be interested in the project as we started it in June, till Aug 7th, less the chimney. Will make one more item for the furnace, a rake to remove the ashes, then it will be wood time after the potatoes are dug in Sept.Will use the hay wagon to bring the wood home in lengths. It sure was an interesting project for us, a first time for us.I'm off now to sharpen chainsaw chains. Warmest regards, LOU
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
