Posted by philip d on August 09, 2017 at 08:09:01 from (142.68.126.16):
In Reply to: Re: Silage bunker??? posted by cumminspuller on August 09, 2017 at 06:36:24:
I've done it a couple different ways depending on the situation. If we're chopping today and the pile won't be finished and there's several days of heavy rain on the way we will pull the plastic over it and hold it down usually with some bales just to keep all the water off it than pull it off and go chopping again. Heavy rain on the fresh uncovered pile will do damage to the nutrients as well. It won't be air tight but will protect it from rain till the weather clears. If were doing a pile and for whatever circumstances its going to be a bunch of days to complete say half way finishing a pile we'll roll the plastic out and stop close to where the face that is still in progress ends and use clay and tires on the completed section. As far as chopping a month apart if it was me I'd cover it airtight as best you can whatever size the pile you complete first will be and leave it be till you start to feed it. These piles to be done with very minimal spoilage seem to require lots of attention to detail to get the best results. We've tried sprinkling barley over piles, taking 2 weeks to make a huge pile than covering it when finished, using bales to hold down plastic basically just sitting on top and rows of bales as a starting wall. All of those resulted in huge amounts of spoilage. Anything we've found here is it cant sit open to air more than a couple of days and the plastic has to be put on tight as an underarmour t-shirt that's 2 sizes too small and stay tight until after you take it off.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.