Posted by pinball on August 20, 2017 at 09:46:05 from (64.49.150.124):
In Reply to: Beginner posted by Ewebb on August 20, 2017 at 07:36:42:
First of all you need to ask your self what are you going to put on your tractor. a small tiller. 2 bottom plow, small disk, cultivator. That will dictate what size you need. is your land pretty flat, somewhat hilly, type of soil. if its already in beans then its probably pretty good soil. are you planning in using a planter or hand planting. several questions you need to ask,. when ever you do decide to do it take some samples to your local place that will test your ground to see what will grow the best. for what acres you are talking about I think any 50 horsepower tractor will work. might need to be a row crop tractor if your going to do a lot of cultivating as they tend to be higher than other tractors. very important to know who you are dealing with as to how long has they had the tractor, what maint they performed. don't know how much experience you have as far as mechanical but if you cant do the work your self you might be in for a surprise. tractor prices will depend on locality . here in Missouri I would suspect you could buy that tractor for 3500 or less. use the internet to find out information on any tractor. do all the research you can especially on parts. problems will arise on tractors and some parts are extremely hard to get. what ever you do I wish you good luck in your adventure.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
