I have owned light, medium and heavy duty rotary cutters of various sizes and manufacturers. Currently, I own a 5' Frontier (sold by JD), a 6' Woods BB720X, and a 7' Woods BB840X. I just sold a 10.5' Woods MDS 1260.
I bought all of these new and shopped Bush Hog, Land Pride and Woods before buying.
You will find that smaller, light/middle duty cutters will have a bushing in the tail wheel while the HD models will have a roller bearing. This is important if you plan to keep your mower awhile. The bushing will be a constant source of maintenance even if you grease it regularly while the roller bearing will last a lifetime, even if you do not.
I have mixed emotions about slip clutches. They work well if adjusted to the HP rating of your tractor and are properly maintained but few are. If you do not loosen your slip clutch and slip it every year or so the clutch pack will rust resulting in no protection of your tractor PTO system. Very, very few folks do this.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
