It did look like there was remnants of a gasket. I scraped it clean and ran the tractor for almost three hours today and so far no sign of oil leakage. I'm not familiar with "non-hardening gasket sealer". I did consider running a thin bead of silicon.
The fluid that was in there makes it appear that everything is rusty. If you wipe it off or look at the wear spots it's not too bad. When mixed the fluid had the look of chocolate milk. Then after it sits it turns more translucent. There was some of the white tell tail signs of water in the fluid but not too bad.
That said, the brown color (colour) had to come from somewhere. Perhaps from the hydraulics that operate the front blade? Speaking of which, The Operator's Manual says the transmission should take 23 pints of fluid. I added 3 gallons (24 pints) and it's still an inch or two below the level of the inspection plug. Thinking about it, the hydraulic lines and cylinder that operates the front blade would need additional fluid. It's run from the transmission sump, right :?:
Except... the level was low before even starting the tractor and all three gallons of oil added can only be in the sump :!:
So, should I keep adding, likely a gallon or more, until the level comes up to the bottom of the inspection plug :?:
Another question, inquiring minds want to know, what is the purpose of the three spring loaded plungers that are compressed when you tighten down the selector lever plate :?:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
