Yuor 400 should have outlets on eiteher side of the dash already, the left ones are just above the battery box and the right side ones are directly under the three hyd control levers. [ hence the three levers] You can get the adapters from a hyd shop, have to order them probably or convert the steel pipe lines from the valve, to hose and run them to where ever you want on the fenders ,etc. Better chance the hyd shop will have metric adapters from valve to normal hose fittings. They orginally came as part of the factory spares parts crate... dealer kept them or lost over time. Depending on what you are using the hydualics for, remember that your main pump is a 9 gpm unit, and 3 gpm is of that flow is directed to the power steering unit, leaving you with 6gpm for other uses... Also don't park the tractor with a strain on the front wheels/steering system, the hyd safety valve tends to lift and the other hyd system[s] in use suffer, even a hard turn against the travel stops while moving can cause the safety to lift at times. Hope it helps
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
